Getting Started
For more information or to purchase this product, visit the LED Flicker/Glow Eliminator product page.
Installation
Note: Installation must be carried out by a qualified electrician only. The circuit breaker must be turned off during installation. Installation must be carried out in accordance with all applicable codes and requirements, including, but not limited to, the National Electrical Code (NEC). Both the Yellow and Blue models install the same.
Turn off the power at the main breaker panel.
Locate the load (red) and neutral (white) wire. Install behind dimmer location or at LED fixture location.
Install the LED filter between the two wires (Figure 1). It may be wired in either direction of the leads but it has to be PARALLEL with the LED light.
Use appropriate wire nuts to make a solid electrical connection. Secure the wires and placement of the LED filter
The LDS-120V has high resistance, dissipates 1.8W and is designed to be directly wired across 120VAC.
Installing the LED filter at the dimmer
Installing the LED filter at the end of the circuit
If the filter is incorrectly installed in SERIES with the load, the LED will stay off. This will not hurt the filter, the dimmer switch or the LED, but the LED will not turn on.
