Locate your device's Set Button

Use this article to help locate the set button on your Insteon Device.

 
Device Set Button Location
Hub (2012) On the back panel, next to the power connector. On Insteon Hub (2012), only use the set button when instructed to do so.
Hub (2014) On the back panel, next to the ethernet connector. On Insteon Hub (2014), only use the set button when instructed to do so.
Hub Pro On the back panel, next to the power connector.
Dimmer Module On the right-hand side, beneath the bright and dim buttons
On/Off Module On the right-hand side, beneath the on and off buttons
Outdoor On/Off Module On the bottom, to the right of the controlled power outlet
LED Bulb

LED Bulb does not have a set button. To "press" the set button, follow the following steps:

  • Connect LED Bulb to power
  • Unscrew (or disconnect power) LED Bulb
  • Reinsert (or reconnect power) to LED Bulb
  • LED Bulb will "press" a virtual set button
LED Bulb for Recessed Lights

LED Bulb for Recessed Lights does not have a set button. To "press" the set button, follow the following steps:

  • Connect LED Bulb to power
  • Unscrew (or disconnect power) LED Bulb
  • Reinsert (or reconnect power) to LED Bulb
  • LED Bulb will "press" a virtual set button
Mini Remote (Wireless Switch) On the bottom, between the Micro USB connector and On/Off Switch
Mini Remote (4-Scene) On the bottom, between the Micro USB connector and On/Off Switch
Mini Remote (8-Scene) On the bottom, between the Micro USB connector and On/Off Switch
Dimmer Switch Beneath the paddle, in-line with the switch trim
Dimmer Switch (1000W) Beneath the paddle, in-line with the switch trim
Dimmer Switch (2-Wire) Beneath the paddle, in-line with the switch trim
On/Off Switch Beneath the paddle, in-line with the switch trim
Dimmer Toggle Switch Beneath the toggle switch
On/Off Toggle Switch Beneath the toggle switch
Dimmer Keypad (6-Button) Beneath the Off button, in-line with the keypad trim
Dimmer Keypad (8-Button) Beneath the G and H buttons, in-line with the keypad trim
On/Off Keypad (6-Button) Beneath the Off button, in-line with the keypad trim
On/Off Keypad (8-Button) Beneath the G and H buttons, in-line with the keypad trim
Dimmer Outlet Between the upper and lower outlets
On/Off Outlet (2011) Between the upper and lower outlets
On/Off Outlet (2014) Between the upper and lower outlets. Each set button controls the outlet to which it is nearest.
Wired Thermostat Beneath the cover, in the lower left-hand corner (later versions have the set button exposed through the cover)
Wireless Thermostat Beneath the cover, in the lower left-hand corner
Venstar Thermostat Adapter On the right side, next to the status LED
Open/Close Sensor For models manufactured in 2012 or later, on the top, to the right of the status LED. For models manufactured prior to 2012, beneath the cover between the external sensor terminals and the jumper pins.
Hidden Door Sensor On the top, towards the rear of the sensor in a recessed cove
Motion Sensor Beneath the rear cover, to the right of the jumper pins and sensitivity dials
Leak Sensor On the top, to the right of the status LED and antenna
Smoke Bridge On the right-hand side
IO Module On the right-hand side, next to the status LED
Ceiling Fan Controller On the end nearest the wires, labeled Fan and Light
Dimmer DIN Rail Module On the front, beneath the paddle
On/Off DIN Rail Module On the front, beneath the paddle
Dimmer Micro Module In the upper left corner, beneath the Bright and Dim buttons
On/Off Micro Module In the upper left corner, beneath the On and Off buttons
Open/Close Micro Module In the upper left corner, beneath the Open and Close buttons
0-10V Ballast Dimmer On the right side, next to the status LED
Dimmer In-Line Module On the front, beneath the Off button
On/Off In-Line Module On the front, in the lower left corner
220V Load Controller (Normally Open) On the front, to the left of center
220V Load Controller (Normally Closed) On the front, to the left of center
Door Lock and Deadbolt Controller On the right-hand side, next to the status LED
IR Transmitter On the right-hand side, next to the status LED
IR Receiever On the right-hand side, next to the status LED
Serial Bridge On the right-hand side, next to the status LED
iMeter Solo On the right-hand side, next to the status LED
SynchroLinc On the right-hand side, next to the status LED
Range Extender On the right-hand side