Change LED Brightness Levels (Keypads)

Adjust LED Brightness

Keypad LEDs can be set to any one of 32 brightness levels.
If KeypadLinc in 6-Button Configuration
 

1. Simultaneously tap the A and D buttons

                            Keypad will beep
 

1. Use the On and Off buttons to adjust the LED brightness
    
2. When you have reached the desired brightness, simultaneously tap the A and D buttons again

                            Keypad will beep

If Keypad in 8-Button Configuration
 

1. Simultaneously tap the C and F buttons

                            Keypad will beep
 

1. Press and hold the On button to adjust the LED brightness. (The button will toggle between brightening and dimming.)
    
2. When you have reached the desired brightness, simultaneously tap the C and F buttons

                             Keypad will beep

On/Off Keypad Setup

The content of this article applies to both Insteon On/Off Keypad (8-Button) and Insteon On/Off Keypad (8-Button).

Getting Started | Guides and Manuals | Going Further | Product Registration

Getting Started

Turn off power at the service panel and remove the existing wall switch.

Unfold all of the wires from the junction box. Separate the black wires and cap them with wire nuts.

If your switch's wires do not match the diagram, consult the additional wiring diagrams available below.

Turn on power and use a voltage detector to identify the live wire; this is your line wire.

Turn off power and connect the corresponding wires from the junction box with the Insteon Wall keypad and cap them with wire nuts.

Install Insteon Wall Keypad, attach the wall plate and turn on power.

Follow the on-screen instructions in the Insteon app to add On/Off Keypad.

---

Guides and Manuals

Quick Start Guides

Owner's Manuals

---

Going Further